Tuesday, October 16, 2007

Cute Project - By Jennifer Murphy



Making the body and head:
1. Cut two orange felt circles 4" and 5.5" in diameter.
2. With heavy waxed thread or dental floss doubled over and knotted at one end, run a gathering stitch around the outside of the smaller circle.Leave open. This will become the head for your pumpkin man.
3. Pack a small ball of Excelsior (wood shavings) in a ball slightly larger than the desired size for the finished head.
4. Place the excelsior ball into the felt circle. Pull thread tight. While holding the felt ball stitch around the opening again and knot closed.You may need to stitch around the opening a third time to pull the opening closed securely. Clip thread.
5. With black floss, sew lines onto the head running the thread from the bottom opening to the center top of the head.
6. Repeat above steps for the larger circle to make the body.Making the Face:While everyone can create their own expression for their Jack-O-Lantern, here are the instructions for making one like mine!
7. Cut 2 small triangles for eyes. Place triangles on head and secure with a drop of glue, and stick small black pins to hold in place and look like eyes.
8. Use another black pin in the middle of head for nose.
9. Cut a strip of felt about 1" long with pinking sheers, cut the bottom off in a crescent shape. Stick in place with a dab of glue. Temperately hold in place with pins.Assembly:
10. Cut a piece of heavy wire about 2" long. Stick one end into the bottom of the head. With a large needle make an opening in the top of the body. Fill the opening in the head with glue and stick the two pieces together.
11. Make another opening in the body with the large needle for the pipe cleaner arms and legs. You may need to "thread" the needle with the pipe cleaner to get them to easily come through the body.12. Cut the arms for desired length. Fold the pipe cleaner legs in half and push the end back into the body. If you are using fluffy pipe cleaners trim the ends be more slim. Bend into place.Final Touches:
13. Trim a small velvet leaf into a bow tie shape. Place a small brad or gold pin in the center and press thisinto the pumpkin at the base of his neck. Dab a little glue onto the back to hold in place.
14. Place the rest of the brads or pins as buttons down the front of the pumpkin. Glue as needed.
15. Cut down another fabric leaf to about 1/2" leaving the long wire end attached. Bend about a 1/4" below the leaf.Make an opening in the top of the head, and with a dab of glue stick the leaf and wire into place. Once dry, spiral the wire around a needle.
16. Create your paper greeting for your pumpkin to hold... glue in place.

____


I saw this project on Martha yesterday and thought it was so cute. The design is by Jennifer Murphy who also has ready made pieces for sale on her eBay site .

3 comments:

Jen Kershner said...

Love, love, love that project. I'm quite sure I don't have time to do it before Halloween but I would love to save it to do later.

By the way, I'm a huge Barack Obama fan too. I've loved him since way back. Jen

nasty_wench, AKA sharon-lizette said...

Yes, I love Jennifer Murphy's bears and cool tutorials too! I wish she'd write a how-to book!

Britt- Sparkled Vintage Charm said...

sooo cute!! I saw that show and want to make those bears. very cute!

Related Posts Plugin for WordPress, Blogger...